Methods to Relight Your Furnace Safely

Nothing is worse than waking up in the course of the winter to seek out that your furnace has gone out, leaving you and your property chilly and uncomfortable. If this occurs to you, don’t fear! You’ll be able to simply relight your furnace by following a couple of easy steps. At Air Rescue, we need to make sure you keep protected whereas performing this activity, so listed below are a couple of tips about relighting your furnace safely.

Examine for Gasoline Leaks

Earlier than doing anything, it’s important to verify for fuel leaks. To take action, flip off all of the fuel valves main into the furnace and take away the entry panel from the entrance of the unit. Don’t attempt to gentle your furnace if you happen to scent a fuel odor from contained in the unit or close to any of the connections. As an alternative, name an expert for assist.

Make Certain Pilot Lights Are Off

Earlier than making an attempt to gentle your pilot lights, ensure that they’re turned off. If they’re already lit if you open up your furnace panel, they might have been lit improperly and may very well be harmful. To show them off, find the pilot valve change close to every burner and switch it counterclockwise till it stops turning. As soon as all pilot lights are off, proceed with warning when relighting them.

Relighting the Pilot Lights

Now that every part is able to go, rigorously comply with these steps:

1. Flip each fuel valves again on (one by one).

1. Maintain down each reset buttons for about one minute every (the reset buttons needs to be positioned close to every burner). This can permit any built-up fuel strain contained in the system to dissipate earlier than lighting. Be sure to launch each buttons solely after each have been held down for one full minute every.

1. Use a protracted match or lighter and ignite every pilot gentle one by one whereas holding down its respective reset button till it stays lit steadily (it often takes about 30 seconds).

1. As soon as all pilot lights have been lit efficiently and stay lit after being reset, change all entry panels onto your furnace unit earlier than turning it again on at its essential energy change location (often discovered close to the place your thermostat is positioned).

Relighting your furnace isn’t as troublesome as it might appear! By following these easy steps from Air Rescue in preparation for lighting your unit’s pilot lights—checking for fuel leaks, and making certain pilot lights are off earlier than making an attempt to relight them—you possibly can be sure that relighting goes easily and safely each time!

When you have questions on your HVAC system or need to schedule a upkeep appointment, contact Air Rescue immediately! We’d be blissful that can assist you discover the right resolution in your wants.