Attain-In Cooler and Freezer Short-term Serivce Valves

Gary McCreadie is an HVAC tech, the creator of hvacknowitall.com and the HVAC Know It All Podcast

When engaged on small, self contained attain in coolers and freezers, you’ll discover a lot of them are usually not geared up with service entry valves for testing, evacuation and restoration.  This makes it tough to troubleshoot if there may be ever a problem with the system, however it additionally helps forestall leaks as there are much less potential leak factors.  

When you come throughout an equipment that isn’t cooling successfully and you believe you studied a leak, a restriction or a refrigerant associated challenge, you’ll need so as to add entry fittings.  Yellow Jacket makes an unbelievable software that may acquire you non permanent entry to the system.  It is a set of pliers, the tip of the pliers have a piercing needle and rubber seat, on the opposite facet of the needle and seat is a 1/4″ service valve.  Merely set the pinch depth and grip the pliers onto the system piping.  You need to use one for the excessive facet and one for the low facet if you need.  After you have decided the problem, you’ll need to recuperate the refrigerant to put in everlasting entry valves.  

Here is a tip, as a result of these kinds of methods include just a few ounces of refrigerant, hauling round a restoration machine is just not all the time obligatory.  A easy evacuated restoration tank ought to be capable of take away the cost.  Arrange a vacuum rated hose to your empty tank and fasten the opposite finish to a vacuum pump (utilizing a manifold gauge is just not obligatory).  Run your pump and pull your tank right into a deep vacuum, you should use a micron gauge positioned on the tank to make sure a deep vacuum has been achieved.  

When the tank has achieved a deep vacuum, connect your charging hose to the system through the non permanent entry valve (pliers) and fasten the opposite facet of your hose to the tank.  Open the tank, the strain distinction between the evacuated tank and pressurized system must be sufficient to recuperate your complete cost typically.  

At this level, you’ll need to put in everlasting entry valves to the system for future reference, testing, restoration and evacuation.  

Gary McCreadie

Comply with HVAC Know It All on Instagram, Fb, YouTube and LinkedIn and LISTEN to the HVAC Know It All Podcast

Save 8% on purchases at TruTech Instruments with code knowitall (excluding Fluke and Flir merchandise)