Comparing High-Efficiency and Mid-Efficiency Furnaces

Whenever you are in the market for a new

furnace

for your

Hubbard

home, there are many models to choose from.  Many of the furnaces manufactured within the last few years are high-efficiency furnaces with a high AFUE rating (AFUE measures the amount of fuel the furnace converts into heat). When people refer to a mid-efficiency furnace, they are usually talking about older furnaces.

Single-stage furnaces were considered to be an efficient heating system when they were manufactured, but compared to newer furnaces, they use up a lot more energy than they need to. Single-speed furnaces are designed to run at full capacity until the temperature inside the home reaches the

thermostat

setting. After they shut off, the home not only loses heat, but the furnace will also take longer and burn more fuel when it cycles on again.

Newer, two-speed and multispeed models run consistently at lower speeds, and the ones with variable-speed blowers are even more efficient because they can operate at various levels. These models will also automatically adjust to the thermostat to maintain a constant temperature, which saves energy by keeping the home at a consistent temperature so that there’s little heat loss.

When shopping for a new furnace, keep in mind that the AFUE ratings for multispeed and variable-speed furnaces only determine the efficiency of the actual furnace. If you are upgrading your old, mid-efficiency furnace to a high-efficiency furnace, you should make sure that your

Hubbard

home is properly insulated and sealed.  You could also consider upgrading any older doors and windows to more efficient double-paned ones, or you can also install storm doors and windows.

The post

Comparing High-Efficiency and Mid-Efficiency Furnaces

first appeared on

Clean Air Act Inc.

.